Music is the ultimate goal of the piano, an objective that sometimes gets lost among the tunings, regulations, voicings, etc., etc., etc. At the same time, we must be concerned with the quality and stability of our work and of that of the instruments. Tone, touch and tune are our daily bread, as they are for the musicians, if in somewhat differing manners.
Of great importance to all is cost, beauty and durability, but the final stone in my echelon of priorities is essentially ours and that of the manufacturers or rebuilders: serviceability. In the designing and fabrication of pianos, and during rebuilding, certain practices, procedures and oversights creep in that can have a dramatic effect on one aspect of serviceability - tuneability. The next time you tune a piano that is pleasure to tune, you can be assured that many factors contributed to that quality. Here are listed few of the possible sources of trouble on those pianos that are not as tuneable.
The tuning pins must be round, with a consistent diameter and radius. Poor pins can be too long, too short, out of round, change dimension from pin to pin and from the top to the bottom of the thread. They can be poorly plated, the threads poorly cut, the metal too soft, the holes out of place and too small for the larger gauges, and finally, they may have unsquare tips. The tuning pin may appear to be a very simple piece of metal, but when carefully considered, its complexity emerges to demand our attention.
Tuning pins that are too tight require much effort that could best be used to control the pitch of the strings. These pins leave one with less than the best feel for the block and what the pin is doing in the block. Tuning pins that are too loose lack ease of control, long term durability and stability of the tuning. Pin block materials and construction need not be discussed here except to define our requirements; rigidity, dimensional stability, resilience and durability. If made and installed with care, all else is fulfilled. What is required at the interface of the tuning pin and the pin block is a slightly different matter. Wood and metal should come together with out any other matter at all; no resins, oils, moisture or carbonized wood. Some tall orders, but the factors of greatest importance are the care in drilling the holes and the cleanliness of the pin and the stringer.
I have seen beckets (the part of the string that goes through the tuning pin) so long that they have been wound part way around the tuning pin in the opposite direction by an adjacent pin. This is a little long; the proper length is through the pin but not out the other side. The reasons for this are that overly long beckets make repinning that block difficult in the extreme because the becket will not come out of the pin without destroying the coil. The overly long becket represents a painful hazard to the fingers when moving the tuning hammer and, finally, it looks tacky.
Coils that are not tight against each other leave a pin too high, tend to cause tuning instabilities and lack the beauty of neatness. On the finer gauges, a becket can be pulled out of the hole over a period of time. This is why old piano makers put four and five coils in the treble; also, the holes in the pins were bigger than the holes in present pins. Three coils are sufficient; two and a half are not.
Tuning pins that have been left too high present several problems to the tuner, not the least of which is tuning instability. These pins will not twist any less than lowered pins, but the twist can be ...
Read more:
https://www.professionalpianotunerlondon.co.uk/post/music-quality-stability-tone-touch-tune-cost-beauty-durability-serviceability
No comments:
Post a Comment