Grand Regulation In Detail - Part 8

In part VII of the series on grand regulation we discussed the two methods of regulation for grands, the Dip and Blow Priority. Now that we know the differences between these two methods, two decisions must be made before Section IV ‘The Touch’ can be begun. The first decision is what procedure to use to accomplish the regulation process. The other decision, depending upon which Priority method was chosen, is to determine the correct measurement for the dip or blow. Once these two decisions have been made, the remainder is a piece of cake. Without these two decisions, regulation becomes a long, hard task with lots of wasted time.

Let us look at some of the many grand regulation procedures that are available to choose from. This list is by no means all inclusive, and just because a certain procedure has been omitted from this list does not infer anything about its relative merits and value to us. 

 

The five procedures listed on the left are Dip Priority, the five on the right are Blow Priority. In viewing this chart you will notice that some procedures have more steps than others. But pay more attention to the order in which these steps are listed. For instance, in procedure no10 the whippens are aligned to the knuckles as step number three. But in step number seven the hammers are aligned to the strings, making realignment of the whippens necessary. Other procedures listed have similar mistakes. I would certainly modify the order of some of these procedures to eliminate such needless doubling back. 

 

If you were to regulate an action, which of these procedures would you choose? Should you select the one that is from the factory manual for the brand of piano being worked upon? If so, then each time you regulated a different brand of piano you would use a different procedure! Needless to say, this is awkward. Or should you select a procedure written by your favourite author to use on all brands of pianos? Chances are that your author’s procedure is different from what the manufacturer calls for, and may not be as detailed as the factory manual. As an example, some pianos have an auxiliary whippen spring. If you did not know this, and the procedure you were using doesn’t mention it, you would probably overlook it. Well then, should you select the procedure that is the most detailed? I don’t believe so. Just because it has 125 steps doesn’t mean that it is better than one with 50 steps!

How do you decide upon a procedure? Obviously, you want the one which is easiest and fastest for you. People differ in their abilities and knowledge. What works best for one technician may be awkward for another. I suggest that everyone make up their own procedure to suit their own needs. In creating your own, remember that the order of steps must be logical so that the minimum of doubling back occurs.

As a help here, consult the Grand Regulation Chart which appeared in the 2nd post of this series on grand regulation. Naturally, you will want to include those steps such as reshaping hammers and rebushing keys that are normally done when regulating an action. Every step should be in a convenient order to go along with how you regulate. Do you bench regulate or do you regulate at the piano, or a little of each? In that case, you have to create your own procedure. 

 

Now that the procedure has been decided upon, next is to decide what measurement to use for the ...

Read more:

https://www.professionalpianotunerlondon.co.uk/post/grand-regulation-in-detail-part-8